Hotwire’s Vibration Isolator was developed to reduce vibration through the mounting structure of a wind generator. It is constructed of aluminum, pipe within pipe, separated by rubber similar to a car engine mount. This is an optional installation that goes at the top of a pole under a wind generator. It is also available as a built-in design feature on Hotwire’s mizzen bracket. Can also be used on other wind generators.
- painted with white polyurethane
- 3.2 pounds
- fits only 1-1/2 inch schedule 40 pipe
We have installed one on the KISSmobile. Our old RV is flimsily constructed and had shuddered noisily when the KISS blades spun. Although it’s an entirely subjective evaluation, our impression is that the noise caused by vibration has been reduced by at least half since the addition of the isolator.
$165.00 BUY NOW
Note: The pole mounting kit is limited to about 104 inches if shipped UPS. Adding the Isolator allows the top of the pole to be 10 feet (because it adds to the height), and still shipp UPS (or FedEx).